Doremi MCSHD User Manual download pdf (Page 54)

10.6 SCSI Setup

The SCSI Setup settings will set the parameters and configuration of the drive(s). These settings are

pre-configured at the factory (when the drives are purchase from Doremi Labs) and typically will not

require change.

SCSI ID (no.) Sets the SCSI ID number of the V1 after restart. Do not use a SCSI ID number

for the V1 that conflicts with any installed drive. The default SCSI ID is 7.

You need to save and restart to apply the changes.

V1 (type) Select between Rec/Play and Play Only.

Important Note: When the unit is in Play Only mode, all operations that write

to the active drive are denied, including record, initialize, format, etc.

Clock Used to set the SCSI speed in MHz;

Width Used to set the SCSI bus width; 16bit

Termination Used to set the Termination mode; This should always be set to ON.

Warning: You should not set the termination to off unless it was originally configured by

Doremi or when requested by a Doremi Labs technician.

10.7 Media Setup

To activate the commands in this section, press TOGGLE. The message “Are you sure?” will

appear on the LCD screen. To accept press ENTER. If you change your mind press ESCAPE.

Mount If you have more than one drive/MD powered up, this command will mount the

next available MD.

Init The Initialize command deletes all previous recordings and files (clips), and

writes all the new set-up parameters selected in the menus on the active drive.

A disk that was never initialized on the V1 will display the message “No MD

Present” until it gets initialized.

CAUTION NOTE !!

Ensure that the settings under OPTION MENU (4) Init Disk are set properly

before initializing the drive.

10.8 Disk Copy

The Disk Copy functions will allow you to copy a whole file or a segment within the same disk or

from one disk to another. The copy operation is based on a Copy Paste approach.

 Load the source file

 Locate to the start of the segment you want to copy and hit IN (optional)

 Locate to the end of the segment you want to copy and hit OUT (optional)

 Go to OPTION MENU (8), the display should be “Copy 1 File ?”, hit ENTER to mark the

segment or file for copy.

V_1.OM.000160.DRM Page 54 of 85 Version 5.2

Doremi Labs

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 84 85

No comments

Doremi MCSHD User Manual Page 54