Doremi MCSHD User Manual download pdf (Page 26)

FF Fast forward control button with a speed of 40 times normal. When the

fast forward is close to the end of the recording, the speed is slowed

down to normal until it reaches the end. Pressing this button again will

increase the speed. There are three speed levels FF+FF+FF.

OPTION + REW Reverse Play. Holding OPTION and then pressing PLAY will cause

the V1 to play video at 100% reverse speed.

OPTION + PLAY Executes the Chase Command. Hold OPTION and press PLAY. See

6.5.

5.2.4 LCD Time Code Display

Figure 20: LCD Time Code Display

The First line of the display shows the following:

 Time location of the video material using the following format: “HH:MM:SS:FF F1/F2”

 "HH" represent the hours from 00 to 23, "MM" represent the minutes from 00 to 59, "SS"

represents the seconds from 00 to 59, "FF" represents the frames from 00 to 24 in PAL

frame-rates, 00 to 29 in NTSC frame-rates and 00 to 23 in 24P-48i frame-rates - "F1/F2"

represent the field: "F1" for odd fields and "F2" for even fields.

 This display shows the Time Code depending upon what the user has selected in MENU (2)

Time Mode. The display also shows Drop/NonDrop information; “.” Means NonDrop and “;”

means DROP frame. Field one shows “.” Field two shows “:” or “;”

The Second line displays the following:

 At the V1 start-up, the bottom left displays the firmware version of the V1, then No Disk and

Scanning messages will alternate on the left side, then No MD Found and Scanning

messages will alternate once a disk is detected and Stop is displayed on the right side until

a valid drive is recognized on the SCSI bus of the V1, in such case No Disk, No MD Found

will disappear and only Stop will be displayed indicating that the V1 is now ready to access

the drive. If No Disk/Scanning is still displayed even though a disk was installed, the V1 did

not recognize the disk. If No MD Found / Scanning is still displayed, it is an indication that

the V1 has detected a disk but it cannot be mounted – refer to paragraph 14.7 for details.

 During transport controls, the current operation is shown on the right side of the display:

Servo-Lock Dot, PLAY, STOP, REWIND, FORWARD, RECORD, JOG, SHUTTLE, VAR.

"VAR" is indicated during play in chase on LTC/MTC or in variable speed from RS422.

 During shuttle movement, the shuttle speed is shown as:

If forward shuttle: ">> xx %" with xx % = 10%, 20%, 48%, 100%, 200%, 500%, 1000%

If reverse shuttle: "<< xx %" with xx % = 10%, 20%, 48%, 100%, 200%, 500%, 1000%

 During segment playback, the remaining time up to the OUT point is shown as "no. :

MM.SS", where "no." is the number of the segment played from 001 to 2047, "MM.SS" is

the remaining time up to the OUT point of the segment played in mn:sec

V_1.OM.000160.DRM Page 26 of 85 Version 5.2

Doremi Labs

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 84 85

No comments

Doremi MCSHD User Manual Page 26