Doremi HDG-20 User Manual download pdf (Page 6)

3 How to Use the HDG-20

On power up the HDG-20 displays the firmware version number for 2 seconds, then it goes in

Display Mode.

3.1 Display Mode

In Display Mode, the HDG-20 shows information about the output of the unit. It basically

displays the output resolution, outputs mode, pattern and genlock status. The picture below

shows the display after a factory reset.

NTSC A = B

SMPTEBar INTERN.

Resolution Outputs

Pattern Genlock Status

When Quick Access in the SYSTEM menu is ON, pressing the UP and DOWN buttons in

Display Mode will navigate through the available test patterns.

3.2 Menu Mode

Refer to the next paragraphs on how to change any parameter; in this paragraph the example

would be how to change the output resolution to 1080i:

1. Hit MENU to go in Menu Mode

2. Use the UP or DOWN buttons to get to “00 FORMAT”, then hit ENTER

3. Use the UP or DOWN buttons to get to “Resolution”, then hit ENTER

4. Use the Up or DOWN buttons to find 1080i, then hit ENTER

5. Hit MENU several times until you exit to Display Mode.

HDG.OM.000248.DRM Page 6 of 24 Version 1.6

Doremi Labs

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

No comments

Doremi HDG-20 User Manual Page 6